Isp-technologies THETA PRE AMP PEDAL Instrukcja Użytkownika

For clean tones use the clean PREAMP and adjust the bass and treble for the desired tone and then adjust the mid and mid-sweep settings. For a more

TYPICAL CLASSIC ROCK SETTING If you are looking for the Classic Rock sound from the 80 and 90s try the settings below as a starting point.

WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of three years f

INTRODUCTION Congratulations on your purchase of the THETA Preamp Pedal. The THETA Preamp Pedal was designed to provide the maximum possible o

THETA PREAMP PEDAL CONTROLS The upper row of controls are for the clean preamplifier. The last control in that row adjusts the threshold of the Decim

power adaptor to a professional +/- 15 volt DC power supply. This allows a 30 volt internal signal swing required for proper headroom and professiona

output of the Distortion circuit is followed by a Level contol circuit. The level circuit provides the output level control for both the PREAMP circui

BASS This control adjusts the amount of boost or cut in the low frequency portion of the spectrum of PREAMP. The available BASS boos

DECIMATOR CONTROL NOISE REDUCTION CONTROL The DECIMATOR control adjusts the THRESHOLD of the Decimator G-String II. The Decimator works with both th

DISTORT CIRCUIT DISTORT ON LED This led located above the DISTORT FOOTSWITCH and indicates when the DISTORT Circuit is active and in t

SWEEP FREQUENCY CONTROL This control works in conjunction with the MID boost/cut control and adjusts the center frequenc